MRF89XAM9A
3.2
Canada
3.2.1
MRF89XAM9A SETTINGS
The MRF89XAM9A module has been certified for use in
Canada under Industry Canada (IC) Radio Standards
To meet Industry Canada (IC) requirements, the
following settings must be observed by the integrator:
Specification (RSS) RSS-210 and RSS-Gen. Modular
approval permits the installation of a module in a host
3.2.1.1
FSK Modulation
device without the need to recertify the device.
Labeling Requirements for the Host Device (from
Section 3.2.1, RSS-Gen, Issue 3, December 2010):
The host device must be labeled to identify the module
within the host device.
The Industry Canada certification label of a module
shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labeled
to display the Industry Canada certification number of
the module, preceded by the words “Contains
transmitter module”, or the word “Contains”, or similar
wording expressing the same meaning, as follows:
Contains transmitter module IC: 7693A-89XAM9A
User Manual Notice for License-Exempt Radio
Apparatus (from Section 7.1.3 RSS-Gen, Issue 3,
December 2010):
User manuals for license-exempt radio apparatus must
contain the following or equivalent notice in a
conspicuous location in the user manual or
alternatively on the device or both.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
The following settings configure the MRF89XAM9A for
wideband digital modulation techniques that conform to
the requirements of RSS-210 Issue 8, Annex 8. These
settings allow higher radio frequency (RF) output
power and greater link budget.
? Bit Rate Setting: 50–200 kbps
- Transmit Power Maximum Setting: 13 dBm
? Bit Rate Setting: 2–40 kbps
- Transmit Power Maximum Setting: 7 dBm
? Frequency Deviation Setting: 200 kHz
? Data Whitening: On
? Lower Frequency Setting: 902.800 MHz
? Upper Frequency Setting: 926.500 MHz
3.2.1.2 OOK Modulation
The following settings configure the MRF89XAM9A for
narrowband operation that conform to the requirements
of RSS-Gen Issue 3. RSS-Gen Issue 3 requires a
much lower power setting than is allowed in Part RSS-
210 Issue 8 Annex 8. These settings are good for
applications that require lower transmit power current
consumption and shorter transmit distances.
? Transmit Power Maximum Setting: 1 dBm
? Bit Rate Maximum Setting: 28 kbps
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR
?
?
?
Frequency Deviation Setting: 200 kHz
Lower Frequency Setting: 902.330 MHz
Upper Frequency Setting: 927.500 MHz
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
3.2.2
HELPFUL WEB SITES
deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Industry Canada: http://www.ic.gc.ca/
? 2011 Microchip Technology Inc.
Preliminary
DS75017A-page 19
相关PDF资料
MRX-001-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-002-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-002SL-433DR-B MODULE RCVR 433MHZ SAW LN 24DIP
MRX-005-915DR-B MODULE RECEIVER 915MHZ 18DIP
MRX-005SL-915DR-B MODULE RCVR 915MHZ SAW LN 24DIP
MRX-007-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-008-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-009-433DR-B MODULE RECEIVER 433MHZ 18DIP
相关代理商/技术参数
MRF89XAM9AT-I/RM 制造商:Microchip Technology Inc 功能描述:915 MHz Ultra Low-Power Sub-GHz Transceiver Module
MRF89XAT-I/MQ 功能描述:射频收发器 868/915/950 MHz Sub-GHz transceiver RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
MRF8HP21080HR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780H-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HR5 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780H-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HSR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780S-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HSR5 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780S-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21130HR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 130W NI780-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21130HR5 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 130W NI780-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray